Secure the Undertaker in the receiver sleeve with pin and clip.
- Attach the cranks U-joint to the receiver assembly with the provided pin and clip.
- Crank the Undertaker down until it begins to touch the ground
undertaker motorcycle trailer 2
- Remove the wheel retaining strap and move it to the other side of the assembly.
Proceed to move the motorcycle front tire into the assembly. Tire FAQ
If the front fender hits on the Undertaker’s crossbar, crank the assembly up off of the ground a little…. then try again.
Secure the wheel strap through the spokes and tighten it down moderately.
- Attach the handlebar straps as shown left.
- Attach the straps to the underside of the bumber. Special Note
Tighten the handlebar straps up moderately and proceed to crank the front tire off the ground.
undertaker motorcycle trailer 3
When the tire is far enough off of the ground for safe clearance, tighten up the handlebar straps enough to compress the shocks less than 1/4 of their travel. - Look at the bike from the rear and tighten the handlebar straps so that the bike sits straight.